Concrete Sealing & Curing

PERMASEAL

Permaseal is a quick drying solvent-based acrylic curing agent for spray application onto new power trowelled concrete floors and is generally applied immediately after completion of the trowelling operation. Permaseal imparts a pleasing sheen, dustproofs, reduces surface permeability, suppresses efflorescence and hardens concrete floors in a single application. Permaseal can also be used to enhance existing concrete surfaces.

AQUACURE

Aquacure is a VOC compliant, quick drying water-based acrylic curing agent for spray application onto new power trowelled concrete floors. Aquacure imparts a pleasing sheen, dustproofs, reduces surface permeability, suppresses efflorescence and hardens concrete floors. Aquacure achieves the highest classification of curing efficiency and may be applied in 1 or 2 coats. Aquacure is non hazardous to the operatives and the environment. Aquacure can be transported and used in confined spaces without special precautions. Aquacure can also be used to enhance existing concrete surfaces

PENTRA-SIL

Pentra-Sil reacts with free calcium compounds in concrete forming complex, insoluble silicate structures which harden the surface of the floor slab and prevent moisture permeating the finished floor.  A low alkalinity and lower viscosity slow the chemical reaction between Pentra-Sil and calcium components in concrete to create deeper and more complete penetration.

Pentra-Sil uses newly developed surfactant chemistry to deliver lithium components into the substrate. This sophisticated  chemical technology makes Pentra-Sil superior to older silicate based surface sealing products which have been marketed for decades with few improvements

PERMATHANE

Permathane is a single pack, moisture-cured, urethane coating. It is a heavy-duty coating and surface impregnator which penetrates deep into the concrete matrix to reinforce floors that exhibit dusting or surface degradation.This product produces an extremely tough and chemically resistant finish.

PERMAFLEX 'C' CONCRETE CRACK & JOINT REPAIR RESIN MORTAR

The mortar has been designed for the repair of existing concrete floor expansion joints, joint nosings and very badly spalled arrises and joints. It can also be used as a resin mortar for concrete and crack repairs. The cured mortar is exceptionally strong with a modest degree of elasticity and has a fast setting time.

PERMAFLEX JOINT SEALANTS

Permaflex is a range of 2-part, catalyst-cured, self-levelling sealants for load bearing saw cut or preformed control joints which require a higher degree of joint arris protection from the impact of wheeled traffic that can be provided by traditional jointing sealants. Permaflex is designed to provide penetration into joints as narrow as 2-3mm wide and is available in two degrees of hardness and flexibility. It is generally accepted, when employing modern flooring construction techniques, that a narrow 3mm joint will provide superior performance when compared to a wide joint. Conventional jointing materials are not recommended for joints under 6mm.

Permaflex T

Permaflex T is a two stage jointing system for sawn or formed joints in concrete floors.  Permaflex T Tape is a pre-compressed tape that is installed into the saw cut or formed joint and opens up as the joint opens.  Once the joint has fully opened the Permaflex T resin can be installed so that it impregnates the tape thus sealing the joint.  The introduction of the resin only needs to be carried out in trafficked areas as the T Tape will prevent detritus from entering the joint.  Permaflex T can be pre-installed in our AlphaJoint and BetaJoint floor joint systems.

PERMAJOINT

The PermaJoint extruded profile is designed to fill shrinkage saw cut joints in industrial and commercial flooring immediately after the cutting process, this is to ensure protection for the joint edges and prevent expensive joint damage. The benefits of PermaJoint are that it can be very quickly installed to provide immediate protection to sawn joints.